Traktor Pro 4 vs Native Acces won't start

Tractor Pro 4 won't start to work in combination with native access (1.8) (macbook pro M1, Sonoma 14.6.1) and the S4 MK3 :(

Tried everything but it just doesn't work

Native access keeps hanging (I'm going through the installation process) but after starting Traktor Pro 4 (I also have traktor pro 3) the software hangs in 3 options (demo, buy, active) of course i activated with Native Access but but at the end of the installation it hangs.
While the serial numbers are listed in Native Access but it just won't make contact with each other.

Then removed everything from my mac
Reinstalled again (with several startups)
also gave full disk permissions NTKDaemon and Native access access
but I can't get the entire Native system to work :(

God Damnn :(( ppfff

Find more posts tagged with

Native Access

Traktor Pro 4

Accepted answers

Chestnut408

Hé,

Thnx a lot for your reactions 🙏

It's resolved via chatgpt.
The problem was in NTKDaemon.

After a lot of work, everything is working again.
Thanks a lot 🙌👏

All the best

All comments

PoorFellow

https://community.native-instruments.com/discussion/46480/traktor-pro-4-vs-native-acces-wont-start

native access (1.8)

There appear to be some confusion here , "native access (1.8)" as far as I know is not a valid version number.

the serial numbers are listed in Native Access

As far as I know then N.A. does not list serial numbers ?

Generally then from your description it's bit hard to get a good overview of what is the actual state of your setup and what is the actual situation.

Is the latest version of Native Access for your OS and Apple silicon downloaded and correctly installed ? What is your N.A. version ?

Do ALL NI apps including NTKDaemon have full disk access. : How to Enable Full Disk Access on macOS

and do the disks have correct format : Notes on Network Drives and Disk Formats

Also then please check that iCloud Private Relay has been turned off (applies to download problems only) : Native Access Error Message: "Download failed" (macOS)

Also then do not use Clean My Mac.

Also then please supply screenshots of any error messages.

Chestnut408

Hé,

Thnx a lot for your reactions 🙏

It's resolved via chatgpt.
The problem was in NTKDaemon.

After a lot of work, everything is working again.
Thanks a lot 🙌👏

All the best

Quick links

Unanswered questions