Relative Mode not working on M32 Encoders (Mac Sequoia)

SquirrelWerewolf
SquirrelWerewolf Member Posts: 1 Newcomer
in Komplete Kontrol

I bought a Komplete Kontrol M32 yesterday.

After following the install guides to the letter, everything is working except the Relative Encoder Mode in KK.

When I select Relative Mode, the encoder jumps from 0-127 or back again, instead of being incremental. This is reflected in the display on the M32.

I even factory reset my Macbook Air M1 (latest version of Sequoia) and started everything from scratch. No bueno. Selecting relative mode on the encoders in KK makes them jump from highest to lowest or the other way around.

I then installed everything on my Windows 11 PC and Relative mode WORKS! :/

So it might be a software issue on the Mac. I have gone in to every MACOS permission and granted all the NI apps full access to drives and network. Maybe it's just an issue with the latest Sequoia? I might try downgrading back to Sonoma.

Is anyone having this issue? Komplete Kontrol and M32 on latest version and firmwares.

Tagged:

Answers

  • Uwe303
    Uwe303 Moderator Posts: 4,797 mod

    Hello,

    if you set the encoders to relative mode the receiving program has to support it too otherwise you get this behavior. But you don't need the m32 in midi mode with komplete kontrol it is already mapped.

Back To Top

Categories