Control Setup Issues on Logic Pro 11 with Maschine Mikro Mk3 & Komplete Kontrol M-32

Gabriel Matos

Hi there! Hope you´re doing well.

I´ve been trying to setup my controllers (MM Mk3 & KK M-32) to Logic and only they keys and the pads seem to work. The Buttons aren´t automatically assigned.

I´ve downloaded the latest firmware (2020) for both devices and even though I used Rosetta to open the Update Application, they wouldn´t work…

On NI website they have the list of the M chip compatibility, and both devices are included but maybe they should revisit these products.

A lot of musicians still play with them and it´s a shame that they aren´t functioning.

Does anyone know an alternative?

Thx

Jeremy_NI

The Maschine Mikro MK3 and M32 are compatible with the latest Mac operating software. What exactly is not working?

The Buttons aren´t automatically assigned.

What do you mean by that?

Do you mean that transport and other functions do not work?

Regarding the Maschine Mikro MK3, I'm not sure why you would want to have the Mikro MK3 and the M32 to both have transport control. The Maschine Mikro Mk3 template needed to operate this has no note number of pads, which makes it not so useful. However, if you absoluely need it, then follow these steps: Setting up Your Maschine Controller for Host Transport Control in Logic Pro

Now about the M32, is everything functional in Komplete Kontrol in standalone? Do Komplete Kontrol, Maschine and Logic all have full disk access? How to Enable Full Disk Access on macOS

What's your operating system by the way? For Sequoia there are a few more settings necessary:

https://community.native-instruments.com/discussion/39436/tip-sequoia-adds-an-extra-step-when-installing-ni-hardware-keyboards-or-maschine-and-native-access

If transport is still not working with the M32 in Logic, try the following: https://knowledge.apogeedigital.com/how-to-reset-logic-pro-trash-preferences

Jeremy_NI

The Maschine Mikro MK3 and M32 are compatible with the latest Mac operating software. What exactly is not working?

The Buttons aren´t automatically assigned.

What do you mean by that?

Do you mean that transport and other functions do not work?

Regarding the Maschine Mikro MK3, I'm not sure why you would want to have the Mikro MK3 and the M32 to both have transport control. The Maschine Mikro Mk3 template needed to operate this has no note number of pads, which makes it not so useful. However, if you absoluely need it, then follow these steps: Setting up Your Maschine Controller for Host Transport Control in Logic Pro

Now about the M32, is everything functional in Komplete Kontrol in standalone? Do Komplete Kontrol, Maschine and Logic all have full disk access? How to Enable Full Disk Access on macOS

What's your operating system by the way? For Sequoia there are a few more settings necessary:

https://community.native-instruments.com/discussion/39436/tip-sequoia-adds-an-extra-step-when-installing-ni-hardware-keyboards-or-maschine-and-native-access

If transport is still not working with the M32 in Logic, try the following: https://knowledge.apogeedigital.com/how-to-reset-logic-pro-trash-preferences

Gabriel Matos

Nice thank you so much so much for you help !
I will definitely try these x