MASCHINE MK1 UPDATE

GIOVAN
GIOVAN Member Posts: 4 Newcomer
edited November 7 in Maschine

WHAT FIRMWARE UPDATE MASCHINE NO PC ?

Tagged:

Best Answer

  • Sunborn
    Sunborn NKS User Library Mod Posts: 3,088 mod
    Answer ✓

    @GIOVAN please use only English language in the forum, thank you.

    To answer your question, no it is not possible to reset it to start the controller's original factory system. And as i wrote, there is no firmware update for this device.

    You pads are not responding, most probably because this device is very old and over-used. I had a similar problem with the same device, with some of its knobs. This is normal, sadly, for most modern electronic devices, they do have a small life-circle.

    The only possible solution (though there is no guarantee that it will work!) is to take the device to a good electronics engineer to open it and clean it.

Answers

  • Sunborn
    Sunborn NKS User Library Mod Posts: 3,088 mod
    https://community.native-instruments.com/discussion/38175/maschine-mk1-update

    There is no Firmware update for Maschine MK1.
    Only drivers (newer one is from 2015). Check here:

    https://www.native-instruments.com/en/support/downloads/drivers-other-files/

  • GIOVAN
    GIOVAN Member Posts: 4 Newcomer
    edited November 9

    Translated by Mod:

    Are the links above drivers for a computer? I have the Maschine MK 1 firmware version 1.7 and there are problems with no responses on the pads 1,5,9,13, which do not work when I make a pulse contact. Is it possible to reinstall the same firmware or reset it to start the controller's original factory system?

  • Sunborn
    Sunborn NKS User Library Mod Posts: 3,088 mod
    Answer ✓

    @GIOVAN please use only English language in the forum, thank you.

    To answer your question, no it is not possible to reset it to start the controller's original factory system. And as i wrote, there is no firmware update for this device.

    You pads are not responding, most probably because this device is very old and over-used. I had a similar problem with the same device, with some of its knobs. This is normal, sadly, for most modern electronic devices, they do have a small life-circle.

    The only possible solution (though there is no guarantee that it will work!) is to take the device to a good electronics engineer to open it and clean it.

Back To Top

Categories