Cannot select pedals S61 Mk3

Pipe Dreams

The instructions to select pedals for calibration etc. do not work. The instructions say “Knob 1 - Select Pedal”. On my Mk3, Knob 1 says “Mode Switch”. A button to select “Select Pedal” simply does not exist. I’ve tried everything - but either missing something or something wrong with newest firmware update.

Uwe303

You push the 4d encoder to the right, you don't turn it. Then you can set it to continuous and calibrate it The manual is for the old firmware before the midi template integration.

Pipe Dreams

UWE!! That was it!!! Can’t believe how long I spent trying to do that - forgot the encoder pushes directionally - I was pushing it down and turning it (don’t I feel stupid).. Thanks so much.

Uwe303

Hello,

on this page you use the 4d Encoder to select the pedal input you want to edit. And you can only caliibrate if you set it to continuous.

Jeremy_NI

What Uwe said. What kind of pedal are you trying to set up?

Pipe Dreams

Pedal #2 is expression - Yamaha FC7. I am stuck on Pedal #1 - can’t move the selection to the 2nd pedal in order to calibrate it. NI says Knob 1 changes the selection-it doesn’t. The encoder doesn’t change to the 2nd pedal. None of the knobs/buttons do either.

Uwe303

You push the 4d encoder to the right, you don't turn it. Then you can set it to continuous and calibrate it The manual is for the old firmware before the midi template integration.

Pipe Dreams

UWE!! That was it!!! Can’t believe how long I spent trying to do that - forgot the encoder pushes directionally - I was pushing it down and turning it (don’t I feel stupid).. Thanks so much.

Uwe303

Haha no problem, important is, that you can do now your stuff and have fun again making organized noise