Arp will not stop
I spent a lot of time configuring a Kontakt arp (Bell Drops) just the way I want it, but suddenly, it will not stop playing after resetting my DAW engine (Sonar) or anything else I can find to do. If I restart the project, it is OK until I hit that section of the track where the ARP starts. Then it will continue playing. I hate to redo this, and want to know what I can do about it anyway for future reference. Solutions?
0
Best Answer
-
Hello,
maybe you have latch enabled, click on "ARP" then on the left you have "global settings" and there "latch" it should be off in your case i would say.
0
Answers
-
Hello,
maybe you have latch enabled, click on "ARP" then on the left you have "global settings" and there "latch" it should be off in your case i would say.
0
This discussion has been closed.
Back To Top
Categories
- All Categories
- 18 Welcome
- 1.7K Hangout
- 67 NI News
- 896 Tech Talks
- 4.6K Native Access
- 17.8K Komplete
- 2.2K Komplete General
- 4.8K Komplete Kontrol
- 6.3K Kontakt
- 1.1K Reaktor
- 407 Battery 4
- 917 Guitar Rig & FX
- 465 Massive X & Synths
- 1.5K Other Software & Hardware
- 6.4K Maschine
- 8.2K Traktor
- 8.2K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators