Hardware Synths and USB with Maschine+

Just done an experiment because of the zero cv/gate on maschine+.
So I directly connected my series of Behringer "tribute" synths to the M+ via USB in standalone mode.
Everything worked straight off (remembering to allocate in M+ MIDI settings and pad assignment - the synths show up under their recognisable names). The patch bays on the Behringers worked fine as a bounce on to a eurorack and also worked on MIDI transmission chain! Nice!
Tested on TD-3, Craver, Model D, Neutron and Pro-1.
Anyone got other results with other hardware synths / manufacturers?
Comments
-
Hi
I use M+ as my main hub and have replaced my Octatrack as my main hub in my setup.
Peak, Analog 4, Analog RYTM
are connected with USB-Midi via a Midihub to a USB port of the M+.
This works perfectly, including MIDI clock synchronization.
I have prepared the midi templates for my external boxes in the software.
Save the files in
\Native Instruments\Maschine 2\Sounds
on your SD-CardHave fun
3 -
So you did not run into this bug which crashes the M+?
I don’t remember if there was an update since then which should have fixed this issue.
0
Categories
- 10.6K All Categories
- 20 Welcome
- 439 Hangout
- 58 NI News
- 203 Tech Talks
- 1K Native Access
- 4.8K Komplete
- 609 Komplete General
- 1.1K Komplete Kontrol
- 1.8K Kontakt
- 475 Reaktor
- 150 Battery 4
- 268 Guitar Rig & FX
- 201 Massive X & Synths
- 210 Other Software & Hardware
- 2.2K Maschine
- 14 Sampling Room
- 2.6K Traktor
- 2.4K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators