Maschine manual errors: Pattern Arrange mode & creating Clips
The Maschine MK3 manual, both online and PDF, has a couple of errors apparently stemming from the 2.12 update's addition of Clips and the introduction of Maschine+.
Firstly, in Working with Patterns and Clips / Patten Basics / Pattern Editor Overview, under Patterns on the Controller, it describes a mode called Pattern Arrange that does not exist, and I'm guessing hasn't since the system was updated to support Clips. The functionality described & shown here is mostly accessed in the EVENTS mode, with some pattern management functions in PATTERN mode.
Secondly, under Working With Clips / Creating a Clip, it says "1. Hold SHIFT + IDEAS (Song)". This applies only to Maschine+; what it should say for MK3 is "1. Press ARRANGER to enter Arrange mode, then press SHIFT + Button 2 (SONG). Alternatively, press Shift + ARRANGER as a shortcut to Arranger - song mode". Then step 2 should be removed as it would repeat part of step 1.
Categories
- All Categories
- 19 Welcome
- 1.5K Hangout
- 62 NI News
- 785 Tech Talks
- 4.1K Native Access
- 16.5K Komplete
- 2K Komplete General
- 4.3K Komplete Kontrol
- 5.7K Kontakt
- 1.6K Reaktor
- 378 Battery 4
- 845 Guitar Rig & FX
- 429 Massive X & Synths
- 1.3K Other Software & Hardware
- 5.8K Maschine
- 7.3K Traktor
- 7.3K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators