Updating a project

firmo
firmo Member Posts: 2 Newcomer
edited October 2024 in Guitar Rig & FX

Hi,

I've opened a quite old project where all guitars were amped through Guitar Rig 5, which doesn't seem to work with Sonoma and Apple M2 Max.

I would like to use in guitar Rig 6 the same rig I've created with version 5, but I'm not able to see which one I've used, because Guitar Rig 5 doesn't work.

Is there any way to do this?

And no...I have no chance to open the project on an older system.

Thank you.

Best Answer

  • firmo
    firmo Member Posts: 2 Newcomer
    Answer ✓

    Thank you sir!

    I’ve found a way to solve the problem after reading another thread here on the site.

    I’ve completely uninstalled Guitar Rig 5. And then reinstalled it. But I’ve also downgraded native access to version 3.2.3.

    That allowed me to use guitar rig 5 through Rosetta. So I was able to save my presets and import them in Guitar Rig 6 for the future…

Answers

  • donmaddonald
    donmaddonald Member Posts: 238 Advisor

    I think you can't do nothing really, as you can't run the plug-in and see what did you use.

    however, my personal suggestion it is to just redo it again by ear it may lead to good result.

    been there buddy! I know it is frustrating. I hope someone has a solution, but I am pretty confident that you can't do nothing if GR5 doesn't work.

  • firmo
    firmo Member Posts: 2 Newcomer
    Answer ✓

    Thank you sir!

    I’ve found a way to solve the problem after reading another thread here on the site.

    I’ve completely uninstalled Guitar Rig 5. And then reinstalled it. But I’ve also downgraded native access to version 3.2.3.

    That allowed me to use guitar rig 5 through Rosetta. So I was able to save my presets and import them in Guitar Rig 6 for the future…

This discussion has been closed.
Back To Top