I would like to use the 8 knobs on the KOMPLETE KONTROL A25 for quick control in Cubase 13, is this

touchup1954

I would like to use the 8 knobs on the KOMPLETE KONTROL A25 for quick control in Cubase 13, is this possible?

The drivers and firmware are up to date.

Cubase is 13.0.21.

In the download cheat sheet it says Cubase and Nuendo will be available in a future update, is it not possible to do this now?

Uwe303

The midi port is wrong, you have to use the non DAW port. Then you should be able to learn the knobs and then of course use them. But you could have also used the new mapping method. Like so:

https://youtu.be/ElAvIx-XSdY?si=liWpDKeBHs41-ps7

mykejb

If you have the A25 in MIDI mode the knobs send MIDI CC messages so you can map those to the QC controls. You set up the mapping in Studio Setup. If you want a screen shot of a working setup I can do one later.

-- Mike

touchup1954

I put the A25 in MIDI mode and mapped it to the QC control in Studio Setup.

But at the last flag, I just have "push buttons, switching, no automation".

I can't get QC control.

Uwe303

The midi port is wrong, you have to use the non DAW port. Then you should be able to learn the knobs and then of course use them. But you could have also used the new mapping method. Like so:

https://youtu.be/ElAvIx-XSdY?si=liWpDKeBHs41-ps7