Traktor Pro 3 with Kontrol S4 (mk1) using turntable with control vinyl

Gotha
Gotha Member Posts: 3 Member
edited October 22 in Traktor Software & Hardware

Hi

I'm using Traktor PRO 3 (Version 3.6.2) and Kontrol S4 (MK1) on a macOS Big Sur (Version 11.7.3) and it works perfectly fine, beleve or not.

Now I'm interested connecting turntable and use control vinyl. Do I need control vinyl MK1 or MK2 and what kind of needle?

Tagged:

Answers

  • lord-carlos
    lord-carlos Member Posts: 3,584 Expert

    You need mk2 vinyl.

  • Gotha
    Gotha Member Posts: 3 Member

    Thanks for your reply Carlos

    I have Ortofon OM PRO S needle. Is it suitable using on time code vinyl?

  • lord-carlos
    lord-carlos Member Posts: 3,584 Expert

    I don't know much about needles. But traktor just needs an ok clean signal and dvs should work.

    I think it's better to have a needles that has less wear on the record. As you would use it all the time on the same. But then again you could just buy a new DVS for 20 bucks if it wears out.

This discussion has been closed.
Back To Top

Categories