Shortcut to use the "Convert to Clip" feature in Maschine?
Hi,
Is there a shortcut to use the "Convert to Clip" feature in Maschine?
I don't know if software manuals are up to date about this.
Have a nice day,
Guitoune
Best Answer
-
cannot be done from the controller (discussed but never implemented). There is a Keyboard shortcut, check page 25 of the software addendum manual available here…
0
Answers
-
cannot be done from the controller (discussed but never implemented). There is a Keyboard shortcut, check page 25 of the software addendum manual available here…
0 -
After trying it, "Ctrl + .", as said in documentation, doesn't work for me...
Does it for you?
0 -
Workes fine for me, but do note, it changes the whole scene to clips.
0 -
First, I can't use "Ctrl + ." to convert patterns to clip, even with a numeric part keyboard... On a non-numeric keyboard (laptop), I tried to use "Ctrl + Shift + ;" to use "Ctrl + .", not working.
And I found that if you want to use "Ctrl + 1", "Ctrl + 2" or "Ctrl + 3" for different views (Ideas, Song, Mixer), you have to own a keyboard with a numeric part...
Please Native Instruments...
0 -
l am not sure I understand??? If I press the Ctrl key and hold it down, then press 1, 2 or 3, on the top row of the KB, the views change no problem...same with Ctrl and . Not quite sure why not having a numeric keypad would be an issue!!! (just to make sure, you do know the "+" means "AND" not to press the plus key)
0
Categories
- 3.1K All Categories
- 15 Welcome
- 156 Hangout
- 23 NI News
- 66 Tech Talks
- 270 Native Access
- 1.4K Komplete
- 149 Komplete General
- 311 Komplete Kontrol
- 534 Kontakt
- 168 Reaktor
- 50 Battery 4
- 88 Guitar Rig & FX
- 71 Massive X & Synths
- 52 Other Software & Hardware
- 765 Maschine
- 579 Traktor
- 531 Traktor Software & Hardware