Maschine Sw Audio interface input ports mixed up ?

Warempel

Since my last update (2.17.4 on OSX 14.0 Sonoma, M1 MB Air), the Maschine SW seems to be routing my audio interface input incorrectly. It doesn't capture the input on my 8th physical port but instead records/plays the input on what is physically the 1st port on that channel. Maschine SW Audio input settings are correctly done and are unchanged from what I had before, when all was fine.

The interface is a Behringer Flow8. It worked correctly until the update. It also works perfectly with Ableton Live.

The audio interface on my Mk3 also doesn't work correctly, and works fine with Ableton.

Warempel

@Jeremy_NI Thanks for your reply. It wasn't the mike access issue but I checked the full disk access and that was the culprit ! It must have been reset when I upgraded to Sonoma.

So I gave full disk access and the problem is solved.

Maschine still doesn't see my aggregate Audio device but I can work round that atm.

Thanks!

LostInFoundation

I don’t know if this is the case, but Sonoma is not yet supported by NI

Edit: correction (even if not relevant to your case)

They updated today their compatibility list for Sonoma, but at the moment only Traktor and Traktor HW are listed as supported

https://support.native-instruments.com/hc/en-us/articles/360014900358-Compatibility-of-Native-Instruments-Products-on-macOS

Jeremy_NI

@Warempel Could it be this issue here? MASCHINE 2 Does Not Receive an Audio Signal with macOS 10.14 (or higher)

When you say the audio interface on the MK3 is not working, could you give more details? What are your audio settings in standalone? Does the Maschine software have full disk access? How to Enable Full Disk Access on macOS

Warempel

@Jeremy_NI Thanks for your reply. It wasn't the mike access issue but I checked the full disk access and that was the culprit ! It must have been reset when I upgraded to Sonoma.

So I gave full disk access and the problem is solved.

Maschine still doesn't see my aggregate Audio device but I can work round that atm.

Thanks!