S61 MK3 Driver only

TonyB · 2023-10-22T07:28:01+00:00

There was an error rendering this rich post.

I contacted support already about it but, I thought maybe some one on the community can help.

I am using WIn 10

I have the welcome screen all the time. Native Access 2 installed so, the Hardware Connection and the Komplete Kontrol 3. Also the firmware has been updated to the latest. One thing I noticed that the driver is there, matter of fact the Kontrol MK3 is in its place on the device manager but, it is loaded with the microsoft driver. Now I tried to replace it but I do not have any otion from the list than the one already installed. I uninstalled thinking I would might pick it up but nothing. I rebooted few time and still no avail. Any chance to have the driver only? I cannot see it on the list on your site apart the firmware. Please help!

Find more posts tagged with

Comments

PoorFellow

More people have asked with respect to 'drivers' and N.I. have no mention of drivers neither in troubleshooting or in Setup section that tells if S-series MK3 has it's own drivers or uses Windows. But I guess that if it exists then it is installed either by Native Access or by Hardware Connection Service..

TonyB

https://community.native-instruments.com/discussion/comment/102161#Comment_102161

All NI hardware have their own driver and unless NI changed something with the Kontrol MK3, I do not know. But, honestly, can spend quite bit money and go trough this. NI should hve already figure out. I followed all that was to be followed and I tried few things on my own and still nothing. That's a bit disappointing.

Quick links

Unanswered questions