Traktor scratch pro 2.0 and Windows 11 issue

ivinyl
ivinyl Member Posts: 9 Newcomer
edited October 22 in Traktor Software & Hardware

I'm having trouble with the software not recognizing the control vinyl and I'm wondering if the issue is Windows 11 not being compatible with Traktor pro 2.0 software?

I'm using Traktor audio 10

Cheers

Answers

  • lord-carlos
    lord-carlos Member Posts: 3,544 Expert

    Do you get no input signal at all?

    Can you share screenshots of your settings? Audio setup, input and output routing.

  • ivinyl
    ivinyl Member Posts: 9 Newcomer

    Sorry about the pics being upside down

  • lord-carlos
    lord-carlos Member Posts: 3,544 Expert

    Can't be asked to look to closely. The upsidedown makes my head hurt.

    But it seems traktor gets a signal:

    What exactly does not work?

    ---------------------------------------------

    Hint for the next time:

    • Open this forum on the computer with traktor.
    • Win + Shift + S to screenshot a relevant part of the screen
    • Ctrl + V into the forum comment.
  • ivinyl
    ivinyl Member Posts: 9 Newcomer

    I do get a signal i can play on line thru pc but not with control vinyl?

    I get a signal on the calibration ( only single circle) but the two buttons next to the play button are greyed out?

  • lord-carlos
    lord-carlos Member Posts: 3,544 Expert

    Do you get any error? Like "low timecode volume" or something similar?

    It's not a phono signal into a line in, is it?

  • ivinyl
    ivinyl Member Posts: 9 Newcomer

    No error!

    The traktor audio ten is receiving phono signal then sends it to the mixer on line in?

  • ivinyl
    ivinyl Member Posts: 9 Newcomer

    I read an article on NI about Windows 11 and compatibility it mentioned Traktor Pro3 but not Pro2 so was thinking it might be a software issue?

  • lord-carlos
    lord-carlos Member Posts: 3,544 Expert

    Traktor starts and gets a signal. I doubt it's an windows 11 issue.

    Signal seems low, but I will check how it looks on my system when I get home.

    You can try to increase gain.


    Normally when you start the DVS the bottom left it should say "Calibrating .. " for a few seconds. At least on traktor 3.

  • ivinyl
    ivinyl Member Posts: 9 Newcomer

    Yeah its not calibrating just waiting?

    Tried the gain no dice

    Cheers for the help much appreciated

  • ivinyl
    ivinyl Member Posts: 9 Newcomer

    Tried to update as there was one in Native Access now it won't even load the programme 😡🤬

    Searched NI forum and turns out pro2 isn't compatible with Windows 11 🤦‍♂️

    Purchased pro3 to be cont.......

    Ps cheers for your time

  • ivinyl
    ivinyl Member Posts: 9 Newcomer

    Downloaded Pro3 worked straight away it was Windows 11

    Cheers once again

This discussion has been closed.
Back To Top