pitch a sound to a hundredth of a tone

Cren Larvor

hello community, is it possible on maschine to pitch a sound to a hundredth of a tone? I see there is a feature to go from semitone to semitone, but no more precise feature. Is this really the case?

Thanks

D-One

Assuming you're talking about the Sampler the above works but its a bit of extra work depending on the scenario.

The regular Tune parameter can also be modified in fine steps by holding shift, from the software or from the controllers; wherever it makes sense Shift can usually be used for fine steps.

100th would be 0.10 or 0.01, not sure I am bad at math 🥲

darkwaves

I'm not quite sure what 100th of a tone would mean, but you have finer control over in the zones tab of the sampler.

D-One

Assuming you're talking about the Sampler the above works but its a bit of extra work depending on the scenario.

The regular Tune parameter can also be modified in fine steps by holding shift, from the software or from the controllers; wherever it makes sense Shift can usually be used for fine steps.

100th would be 0.10 or 0.01, not sure I am bad at math 🥲

Cren Larvor

Hi D-One and Darkwaves, the mail notifications was on my spam sorry.

I'm not good at math either, but the two ways work perfectly well ;)

Thanks a lot for your help 🙏