How to set up sustain pedal? Komplete Kontrol S88mk2

Ken-Ichiro Kosai
Ken-Ichiro Kosai Member Posts: 2 Newcomer

 Obviously, I read over the guide for Komplete Kontrol S88 mk2 (Japanese). I followed it, but sustain pedal (Yamaha FC3A) did not work. Thank you.

Best Answer

  • Ken-Ichiro Kosai
    Ken-Ichiro Kosai Member Posts: 2 Newcomer
    Answer ✓

    Thanks for paying attention to my question.

    I am using the Komplet Kontrol Software.

    I did it after reading a similar QA in the community and fortunately it worked.

    I switched the main unit (keyboard) back on once, then put the pedal in and re-set it as follows.

    Mode = Continuous. Invert = switch to the right. Swap T/R = switch to the left. Assign Type = Ctrl Change. MIDI Channel = 1 ; Number = 64. Range from 0 to 127. Calibrate - Follow Instructions

Answers

  • RedwardMc
    RedwardMc Member Posts: 81 Helper

    Are you using the Komplete Kontrol Software standalone? Or in a DAW?

  • Ken-Ichiro Kosai
    Ken-Ichiro Kosai Member Posts: 2 Newcomer
    Answer ✓

    Thanks for paying attention to my question.

    I am using the Komplet Kontrol Software.

    I did it after reading a similar QA in the community and fortunately it worked.

    I switched the main unit (keyboard) back on once, then put the pedal in and re-set it as follows.

    Mode = Continuous. Invert = switch to the right. Swap T/R = switch to the left. Assign Type = Ctrl Change. MIDI Channel = 1 ; Number = 64. Range from 0 to 127. Calibrate - Follow Instructions

  • JesterMgee
    JesterMgee Member Posts: 1,499 Expert

    For a sustain pedal, the "Mode" should not be continous, that would be for an Expression pedal so you must be reading the wrong info for a Sustain pedal.

    Should be:

    https://support.native-instruments.com/hc/en-us/articles/115005166305-How-to-Configure-Sustain-Expression-Pedals-on-KOMPLETE-KONTROL-Keyboards

Back To Top