Signal Path

knobblyknee

Is there a way to re-route the signal path so that the filter on the mixer comes before the FX section? Atm, the filter cuts out any fx I have on the track and I want to leave the delay or reverb still in the mix when I use the filter.

cheers

PZZO

You can set the FX Unit Routing to Post Fader, which applies the FX on the channel after the EQ/filters/fader.

By default this is Insert, which applies the FX on the raw channel input before EQ/filters/fader is applied from the mixer.

Hope that helps!

LostInFoundation

I can’t recall for sure…but isn’t there a filter also in the FXs? You could use this

Sûlherokhh

https://community.native-instruments.com/discussion/comment/64519#Comment_64519

True. The sequence of the FX signal path is FX 1, 2, 3 (Unit 1), FX 1, 2, 3 (Unit 2), etc. So put it in Unit 1, first effect.

knobblyknee

https://community.native-instruments.com/discussion/comment/64519#Comment_64519

Thanks. Yes, I have been using this but guess I'm just greedy for more fx!

Also think it would be useful as an option for other things too.

PZZO

You can set the FX Unit Routing to Post Fader, which applies the FX on the channel after the EQ/filters/fader.

By default this is Insert, which applies the FX on the raw channel input before EQ/filters/fader is applied from the mixer.

Hope that helps!

knobblyknee

Awesome. Thanks