Using Reverse Grain and Sequencer - Annoying Buzzes
Okay I am out of options here. I've been using Guitar Rig since Version 4 and I have always struggled with this: sequencing the Grain Reverse Module with a sequencer - Step or Analog, it's always producing the same annoying buzzes. Why? What would you do to sequence a reverse effect that happens at the 4th bar of a sequence?
Thanks in advance!
Answers
-
What parameters of Grain Reverse are you modulating / sequencing with Step and Analog? Since it is a granular delay effect, when making rapid changes it can create glitchy buzzes.
0 -
I am using a step sequencer element to activate "Rev" button at certain moments in a 4-bar sequence.
The steps have maximum decay and width is turned up as well. This happens with the step sequencer as well with the analog sequencer. If you use an LFO, the buzz does not occur - why? This used to work before in GR5 - and by the way, it used to be a bug there a long time ago until it got fixed - I am still trying to wrap my mind around the fact that it happens again in GR6...
0 -
@dreikelvin Could you do a short video (with sound) showcasing the issue and upload it here? Could you also upload a small project here where the issue occurs? This way we could try and reproduce the issue, show it to the devs, file a bug if needed.
0 -
Sure. Here we go:
it's all in the ZIP
0
Categories
- All Categories
- 19 Welcome
- 1.4K Hangout
- 60 NI News
- 764 Tech Talks
- 4K Native Access
- 16.3K Komplete
- 2K Komplete General
- 4.3K Komplete Kontrol
- 5.6K Kontakt
- 1.6K Reaktor
- 374 Battery 4
- 833 Guitar Rig & FX
- 424 Massive X & Synths
- 1.2K Other Software & Hardware
- 5.7K Maschine
- 7.2K Traktor
- 7.2K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators