Hi lovely community,
im using an external mixer and bevor i used the pattern player i recorded my music internal with traktor.
For this i used 'input fx return' and mapped it to channel 11/12 from my xone96. Activated the little push button/ switch to send master out trouhg channel 11/12. And in the 'mix recorder' setting i set 'ext. input' to 'input fx send'. Worked well for years 🎉
Now with the new pattern player i want to use it in 'send mode' and set 'output fx return' to channel 09/10 but now the pattern player gets recorded still when i put my fader down. only when i stop it or mute it in the software direct it works.
Is there a way to record internal while using pattern player in send mode with a xone96? if yes how the config looks like.
(on the picture 26170222 -> all track channels are paused or faders down - on the recodring monitor on the right side you see still signal from the pattern player (and its on the recording also))
I want to use the xone channel fader instead the dry/wet button on my x1 to adjust the volume.
thank you very much in advance
slayer741
(edit: grammar, typo)