Maschine+ strange encoder behavior (hardware issue)
Hey there. I'm pretty sure I have a hardware bug on my beloved Maschine+ but I thought I throw that in here first before sending it in.
Problem: One of the Encoders is behaving strange. When I move it in either direcion it starts to adjust the parameter up and down in a circular pattern. Means, when I move the encoder upwards it may start to bring the parameter up for a bit but then changes its direction downwards and then back upwards after a bit. I was a bit jittery for some time but now it's pretty constant.
The problem occurs on all instances: Standalone, in Maschine Software (PC) and even reflected in the NI Controller Editor.
I usually have a Maschine Jam, an Iconnectivity Midi Router and Tascam Model 12 connected. A Restart with everything disconnected doesn't solve the issue.
I just tried a hardware reset: still the same issue.
Are there any other ideas to solve the problem? Or is it likely to be a faulty encoder?
Love and virtual hugs go to every helping engagement :)
- 3.8K All Categories
- 16 Welcome
- 186 Hangout
- 28 NI News
- 83 Tech Talks
- 325 Native Access
- 1.8K Komplete
- 195 Komplete General
- 382 Komplete Kontrol
- 651 Kontakt
- 207 Reaktor
- 54 Battery 4
- 108 Guitar Rig & FX
- 85 Massive X & Synths
- 72 Other Software & Hardware
- 925 Maschine
- 9 Sampling Room
- 735 Traktor
- 649 Traktor Software & Hardware