How can I change the Traktor Kontrol X1 FX knobs to a simple Low Mid High control?

Beat Spichtig
Beat Spichtig Member Posts: 10 Member
edited October 2024 in Mapping Traktor

hy all, am new to this forum, thx for reading and helping.

I would like to use the FX Knobs 4,3,2 of my new Kontrol X1 as Low, Mid and High coltrol and only the knob 1 as a single FX section knob. Does anyone here know the midi assignments to these knobs and the LMH midi numbers?

Tagged:

Best Answers

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,623 mod
    Answer ✓

    This may be more a matter of overmapping the default mapping of the X1 like this.

    Pref.jpg

    The commands to use for the equalizers can be found at 'Add In... ---> Mixer --> EQ'. The check at 'Override factory map' is important. On this picture, the In-Port is set to none because i don't own an X1. If you have yours connected it will show your X1 instead.

  • Beat Spichtig
    Beat Spichtig Member Posts: 10 Member
    Answer ✓

    Ok I just found the solution

    just had to switch devices

    ;].

    works perfekt now

Answers

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,623 mod
    Answer ✓

    This may be more a matter of overmapping the default mapping of the X1 like this.

    Pref.jpg

    The commands to use for the equalizers can be found at 'Add In... ---> Mixer --> EQ'. The check at 'Override factory map' is important. On this picture, the In-Port is set to none because i don't own an X1. If you have yours connected it will show your X1 instead.

  • Beat Spichtig
    Beat Spichtig Member Posts: 10 Member
    edited September 2022

    that should help I guess. Thx.

  • Beat Spichtig
    Beat Spichtig Member Posts: 10 Member

    Thx for showing, it works quite fine… with one X1 controller!

    I guess the second one is being seen as one and the same even though I use it to control deck B and D…

    well, still thank again.

  • Beat Spichtig
    Beat Spichtig Member Posts: 10 Member
    Answer ✓

    Ok I just found the solution

    just had to switch devices

    ;].

    works perfekt now

This discussion has been closed.
Back To Top

Categories