Maschine 3 for Maschine+ ?

Emma Air
Emma Air Member Posts: 1 Newcomer
in Maschine

I can’t find any information about, if the Maschine 3 update is running on the Maschine plus.

Is there some information, is there a plan to run it on the standalone mode. I guess the processing of stem separation could be way to much for the system built in the Plus, but on MPC the did. it. The quality is much worse then on the software running on computers but the did it.

Best Answer

  • tetsuneko
    tetsuneko Member Posts: 884 Expert
    edited November 2024 Answer ✓

    Maschine+ does not yet support 3.0 (Maschine Central which released with 3.0 does work though). OS update for M+ which brings 3.0 compatibility should be releasing soon (during Q4/24 or Q1/25 would be my guess)

    With regards to stem separation, I am not sure it is coming to M+ standalone.. but even if it does not come, you will be able to stem separate on the Maschine 3.0 desktop and then transfer the project back to standalone for further work

Answers

  • tetsuneko
    tetsuneko Member Posts: 884 Expert
    edited November 2024 Answer ✓

    Maschine+ does not yet support 3.0 (Maschine Central which released with 3.0 does work though). OS update for M+ which brings 3.0 compatibility should be releasing soon (during Q4/24 or Q1/25 would be my guess)

    With regards to stem separation, I am not sure it is coming to M+ standalone.. but even if it does not come, you will be able to stem separate on the Maschine 3.0 desktop and then transfer the project back to standalone for further work

  • davomanic
    davomanic Member Posts: 5 Newcomer

    Is Maschine software version 3 compatible with Maschine Plus already?

  • LostInFoundation
    LostInFoundation Member Posts: 5,628 Legend
    https://community.native-instruments.com/discussion/comment/227963#Comment_227963

    If you mean in Standalone, no

  • PK The DJ
    PK The DJ Member Posts: 2,759 Expert

    No, not yet. When Maschine 3 software was released (November) the release notes said that Plus compatibility would be "coming soon"….

Back To Top

Categories