Izotope Ozone EQ 11: RTA questions

Options
Mark Wesse
Mark Wesse Member Posts: 68 Member
edited April 27 in Other Software & Hardware

Simple question but how do you switch input modes for the RTA? ie pre post etc

Also, I work to K-System Ballistics which I can see I would like to modify as all my gain staging is done to -18 and would like to use the eq at head of chain and establish there…is there any other way to manange the graphics (I know release etc is there) as I would like an indicator bar at the -18 or someway to tell as its very difficult on 4k screens

Tagged:

Best Answer

  • Jeremy_NI
    Jeremy_NI Administrator, Customer Care Posts: 14,941 admin
    Answer ✓

    @Mark Wesse There is not currently a way to switch the EQ analysis between pre / post. It is always going to be post EQ.

    There is a workaround however:

    Ozone includes two EQ modules, so you can place one at the start of the signal chain and leave the EQ flat. The RTA in this first EQ will then read as Pre the second EQ module. Not a great workaround but could still be useful.

Answers

  • Uwe303
    Uwe303 Moderator Posts: 4,830 mod

    Hello,

    You can't, as far a so know, it's always post eq. But maybe someone else knows better

  • Jeremy_NI
    Jeremy_NI Administrator, Customer Care Posts: 14,941 admin
    Answer ✓

    @Mark Wesse There is not currently a way to switch the EQ analysis between pre / post. It is always going to be post EQ.

    There is a workaround however:

    Ozone includes two EQ modules, so you can place one at the start of the signal chain and leave the EQ flat. The RTA in this first EQ will then read as Pre the second EQ module. Not a great workaround but could still be useful.

Back To Top

Categories