Ni mashine mk3 & keyboard no display working

Joshb · February 4

I up graded to mashine 3.0 . Now the ni mashine mk3 will not connect and the display screen stop working. On both device komplete 49 a- ni mashine mk3 . Both devices are up to date . I’m Using a powered usb hub . I need help to resolve this issue .

mykejb · February 4

Does the Maschine MK3 work when you use Maschine 2, or does that fail as well? Does the keyboard work with Komplete Control? Do the devices power up correctly when plugged into the computer?

And probably the big question - your profile says you're using Ventura on a Mac. Is that correct, because Maschine 3 requires Monterey or higher according to the requirements page.

Joshb · February 4

Ventura is higher then monterey

Joshb · February 4

it shows its powers up but doesn’t connect and the screens are black

Joshb · February 4

the keyboard display screen is blanks as well

mykejb · February 4

https://community.native-instruments.com/discussion/comment/208886#Comment_208886

Um … that's what I meant 🤣 so ignore the requirements comment!

Have you tried different USB cables, and also plugging in without the hub?

Joshb · February 4

yes both - new cable and powered usb hub

Joshb · February 4

And unpowered usb hub

Joshb · February 4

to no avail-

Joshb · February 4

does any no any place to send for repairs or troubleshooting issue

Joshb · February 4

I so frustrated with it

Jeremy_NI · February 12

@Joshb Please check these articles:

My Komplete Kontrol Keyboard Does Not Start

My Maschine Controller Does Not Start

If it's not working still, please get in touch with our support, if you haven't already: https://bit.ly/NI_support_Kontrol

Joshb · February 16

I set a several message no response

LostInFoundation · February 16

Wait at least till tomorrow (support doesn’t work on saturdays and sundays). If after some more days you get no answer, contact them again.

About the screens: are they completely off or they at least display some logos or “Production & performance system”?

Joshb · February 16

I will keep trying

Jeremy_NI · February 17

https://community.native-instruments.com/discussion/comment/211419#Comment_211419

I don't see any request from you. Please get in touch here and asjk to the chatbot: contact support. Please read the following: https://bit.ly/NI_Support_How

Ni mashine mk3 & keyboard no display working

Answers

Categories