No Assignement Table

D.pi.T
D.pi.T Member Posts: 3 Newcomer
edited October 2024 in Mapping Traktor

Hi everybody,

I'm new in this part of forum.

I buy an X1 mk3 this morning, register him and install traktor pro 3.

I want use classical mode (FX1/FX2/A/B) but the assignement table is empty,

only browser is working….

How can i do ?

Thanks before

Capture.PNG

Comments

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,624 mod

    The assignments are done by qml code. What you see is just for when you want to overmap controls. You can use the controller out of the box.

    What do you mean when you say that only the browser is working?

  • D.pi.T
    D.pi.T Member Posts: 3 Newcomer

    i try to modulate fx or eq it's not working, same for transport section

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,624 mod
    1. Restart Traktor without the X1 connected.
    2. Connect X1.
    3. What do the screens show?
  • D.pi.T
    D.pi.T Member Posts: 3 Newcomer

    I reinstall traktor 3,

    i've again the setup wizard but nothing work…

    Capture.PNG Capture2.PNG 3.PNG 4.PNG
  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,624 mod
    1. Finish/Exit Wizard
    2. Connect X1.
    3. What do the 5 small screens on the X1 show?
This discussion has been closed.
Back To Top

Categories