Does anyone happen to know how I can connect my LEDs from the X one K2 to Beat phase?

Leon Diaz
Leon Diaz Member Posts: 2 Newcomer
edited October 2024 in Mapping Traktor

Hello, I would like my LEDs to flash when the track is playing and preferably with several LEDs from quiet green to loud red depending on the volume, mfg Timo:)

Best Answer

  • Stevan
    Stevan Traktor Mapping Mod Posts: 2,319 mod
    Answer ✓
    Screenshot 2024-01-27 at 10.16.31.png

    It sounds like you are trying to achieve the VU meter and not the Beat Phase LED feedback. If so then check the above command^

    Note that the LED brightness is not possible to control with the K2 controller.

Answers

  • Triggi
    Triggi Member Posts: 49 Helper

    Hi Leon,

    this is an english forum, so you have to weite in english. Then you may expect more answeres.

    Best regards!

  • Leon Diaz
    Leon Diaz Member Posts: 2 Newcomer

    Okay Thx :)

  • Stevan
    Stevan Traktor Mapping Mod Posts: 2,319 mod
    Answer ✓
    Screenshot 2024-01-27 at 10.16.31.png

    It sounds like you are trying to achieve the VU meter and not the Beat Phase LED feedback. If so then check the above command^

    Note that the LED brightness is not possible to control with the K2 controller.

This discussion has been closed.
Back To Top

Categories