Traktor Kontrol S2 and Traktor 3: Loop in and out by pressing the right knob is now random

Options
egotrippi
egotrippi Member Posts: 3 Newcomer
edited October 2024 in Traktor Software & Hardware

Hello everyone,

I have updated to Traktor 3.10.1.16 and since doing so it seems that engaging a loop on both sides of the controller by pressing the right knob (next to the out button) is now random. Sometimes it will engage the loop and sometimes it won't. The software clearly receives the command because I can see the portion being highlighted in green and then disappearing like I clicked again (which I do not).

Does anyone have any clew for fixing this?

Many thanks for your help.

Cheers

Comments

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,641 mod

    Make sure FLUX is OFF.

  • Stevan
    Stevan Traktor Mapping Mod Posts: 2,323 mod

    Perhaps there are two of the same command involved in your mapping. That would explaing described toggle on and off behavior at least.

  • egotrippi
    egotrippi Member Posts: 3 Newcomer

    Thank you both for coming back to me on this 🙏🏻

    Flux was the culprit, all good now 😌

    Cheers

This discussion has been closed.
Back To Top

Categories