Is there a way of obtaining loopback on Komplete Audio 6 using the RCA and jack inputs 3/4?

yccmd

It's obvious now that I tried, as the RCA output has both an in and an out. Still. I should get some signal on the jack input by routing the out from the RCA to it, right? What am I missing?

Jeremy_NI

@yccmd There are no RCA inputs or outputs, those are SPDIF, so, as you mentioned you can't route digital to analog in this manner (or vice versa) https://www.native-instruments.com/en/komplete-audio-6-quickstart/

Uwe303

Hello,

yes if you use the windows audio driver in shared mode it should work. What exactly do you want to route from where to where?

yccmd

I want to loopback the signal from the RCA to inputs 3/4 on the komplete audio 6. which i thought made sense, though I was mainly trying to route digital signal back as audio

Jeremy_NI

@yccmd There are no RCA inputs or outputs, those are SPDIF, so, as you mentioned you can't route digital to analog in this manner (or vice versa) https://www.native-instruments.com/en/komplete-audio-6-quickstart/