install failed but left remnants - how to clean up

Hi,
New to Native Access. Installed software that was included with S series keyboard. All was going well for the most part but the installation of Reaktor 6 complained about a folder setting.
I corrected the folder setting, tried the install again and then the installation succeeded.
But as you can see from the screen shot there is an entry for the failed install - the one showing version 0.0.0.
Can the be cleaned up and, if so, how?
Thanks much.
Frederick
Best Answer
-
That's a weird one. You could try uninstalling Reaktor 6 by using this tool: NI Uninstall RegTool_64bit.zip
Then install from scratch in Native Access.
1
Answers
-
That's a weird one. You could try uninstalling Reaktor 6 by using this tool: NI Uninstall RegTool_64bit.zip
Then install from scratch in Native Access.
1 -
Thank you. I will give that a try.
Frederick
0 -
Did it work out?
0
Categories
- All Categories
- 18 Welcome
- 1.6K Hangout
- 66 NI News
- 863 Tech Talks
- 4.4K Native Access
- 17.7K Komplete
- 2.1K Komplete General
- 4.7K Komplete Kontrol
- 6.1K Kontakt
- 1.6K Reaktor
- 398 Battery 4
- 894 Guitar Rig & FX
- 456 Massive X & Synths
- 1.4K Other Software & Hardware
- 6.2K Maschine
- 7.9K Traktor
- 7.9K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators