Traktor X1 + Xone96 Effects Routing Question

Toltemic · March 22

audio from traktor track A-D → sent to hardware output channel 1 - 4 → channel 1 - 4 send knob directs audio back to traktor (audio input send that you set to send 1) → traktor audio send get sent to fx thats set to 'send' (so it receives audio) but the fx unit is off so the audio just passes through unaffected (with audio buffer latency) → audio from fx unit that's unaffected gets sent to channel B → channel B sends audio to main output

Even if you don't have a slightly offset audio because of traktor processing latency, you'll be amplifying the audio if you turn up channel B whilst audio is being sent from other channels

Delay and reverb on max wet, only sends the echo not the original source audio so you wont get the doubling

Lethendris · March 22

Unfortunately it doesn't work for me. I keep hearing the track. Thanks for all your help but I will stick to using on "Insert" mode unless I get an external pedal or something. I thought I could use it like that and the fact that everyone else but me can make this work makes me think there is something going on with the mixer itself

Sûlherokhh · March 22

https://community.native-instruments.com/discussion/comment/217684#Comment_217684

I have to check how this influences the signal.

Toltemic · March 22

so just to clarify,

you have fx unit set to single with 'delay' and its set to send- the fx unit module itself is set to on, the dry wet knob is all the way right, the mixer send 1 pot is up from 6'oclock and set to postfader on channel 1

when you turn up channel b and channel 1 is playing you still here doubling channel audio with no fx and with a slight latency?

Lethendris · March 22

That's correct. I can see levels moving on channel B even with no fx with Send1 turned up all the way and channel b fader turned up

Toltemic · March 22

no okay you definitely be hearing echo fx of some kind, is channel b is set to receive usb audio?

Lethendris · March 22

If it's the switch above gain on B, yes it's set to Usb1, same as decks

Toltemic · March 22

If swap the audio input to send 2 and return to channel A do you still get no fx even when fx is enabled?

Lethendris · March 22

That's correct if you meant these settings.

When I increase Send2 on channel1, I can see meter moving up even with fader on channel A is turned down all the way.

Could that be the USB 11/12 or MST/SEND2 buttons below Master2 on xone96? USB 11/12 is pressed and MST/SEND2 is not pressed on my case