Shift for fine adjustments doesn't work when editing steps in step mode

S Righteous
S Righteous Member Posts: 166 Advisor
edited October 2024 in Maschine

This is annoying. In step mode, you can hold down a step and adjust parameters for that step, but try to adjust the pitch by an exact amount and you will start screaming. Holding the step, and shift and then adjusting the pitch does not let you fine tune that parameter.

Am I missing something, or does Maschine+ just have the 'appearance' of p-locks without the actual functionality of p-locks?

Tagged:

Comments

This discussion has been closed.
Back To Top