so I have had maschine software for at least 10 years and this still has not been fixed and still occurs on maschine 3. Surprised no one ever mentioned it.
take any sample and drop it into the sampler. Take the slider on the right and move it around and move it all the way to the right again. Now zoom in on the sample. Does it look like the slider goes all the way to the end. No it does not. When I first started using maschine I would hear occasional pops that I could not figure out on sample tracks. I finally started zooming in on the samples and always adjust the right hand side slider zoomed in. Sometimes I’ll just fade out the tracks towards the end of the sample too to make sure the cut occurs with no possible pops.
the reason I had you move the slider on the right was to simulate editing a sample. So you could see the cause of occasional pops that could occur because of where the end of the cut was made.