Mapping mix knob to sample knob

JQ667
JQ667 Member Posts: 1 Newcomer
in Mapping Traktor

I’m sure this is pretty basic, but I’m stuck.
My mix knob on my tractor S2 mk3 seems like it’s losing contact with the board underneath because it only works if I press the knob down a little bit. I’m hoping I can just reap this to the knob right above it and also disable the mix knob. Sample knob never gets used.
I’ve watched a few videos and read some articles, but…I’m struggling to find where to map this knob in controller manager. Any help would be hugely appreciated.

TYIA!

JQ

Comments

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 2,996 mod

    You mean the S2mk2, right? Monitor and Master Gain gnobs are wired to the audio interface outputs and can't be remapped.

Back To Top

Categories