Sonar Plat Doesn't Respond to S88 Mk1 Input

KingKonga
KingKonga Member Posts: 67 Member
in Other Software & Hardware

Hello Gang,

I'm trying to connect my S88 Mrk I to my Sonar Plat (Ver. 23.10). Nothing I do will actually play thru using Sonar. Studio 1 works fine. What am I doing wrong?

Thanks,

George

Best Answers

Answers

  • Jeremy_NI
    Jeremy_NI Customer Care Posts: 12,997 mod

    What version of the Komplete Kontrol applicaton/plug-in are you using? If you own a mk1 keyboard you should stick to 2.9.6 as explained here: Notes on Ending Software Support for Komplete Kontrol S-Series MK1 Keyboards

  • KingKonga
    KingKonga Member Posts: 67 Member
    Answer ✓

    Yes, I'm using Ver. 2.9.6

  • Uwe303
    Uwe303 Moderator Posts: 4,003 mod
    Answer ✓

    Hello,

    maybe that helps, it's the same for the mk1 in terms of midi ports, using mackie protocol and route the keyboard to the selected track.

    https://youtu.be/r27DnyXRMvU?si=w5FI-K6onl98mBow

  • KingKonga
    KingKonga Member Posts: 67 Member

    Sorry guys. It didn't work. I went thru the entire setup, incl. the ACT/Cntrl Surfaces setup. I tried BOTH the DAW AND the Komplete-1 setup, and NOTHING responds with the Mk1. I hit Record on the Mk1 and nothing. I hit Rec in CW, and still nothing. I don't know what else to do.

  • Uwe303
    Uwe303 Moderator Posts: 4,003 mod

    Then I have no further idea, it works in S1 so the keyboard is fine and if you have watched the video and set everything up accordingly, maybe paused the video to have a better look on the settings he shows. The ports are also clear kk-1 is for the keys and if the keyboard is in midi mode for the knobs, this should go to the selected track, kk-ext you don't need (it's for the midi din connectors on the back) and kk-daw is for the DAW transport and track selection controls, you use those ports (in and out) for a mackie control device. All shown in the video - maybe you go over it once more, sometimes one can overlook something very quick.

  • Jeremy_NI
    Jeremy_NI Customer Care Posts: 12,997 mod

    @KingKonga Can you open Controller Editor? Does the MK1 show there? Can you connect it? What version of Controller Editor do you have?

  • KingKonga
    KingKonga Member Posts: 67 Member
    edited October 28

    Thanks Jeremy. When I open Controller Editor, I'm prompted to Connect. So, I'm assuming it DOES NOT see it. The ver. is 2.8.2.

  • Jeremy_NI
    Jeremy_NI Customer Care Posts: 12,997 mod

    Maybe these steps can help: My Komplete Kontrol Keyboard Does Not Start

Back To Top

Categories