Set macro in software when using Maschine as a logic plug-in

S Righteous

I'm using Maschine as a plug-in in Logic. The manual indicates that you can control macros within Logic, which is nice - but when I right click on a parameter I don't get an option to set a macro. Do you have to set macros in stand alone? That would seem weird.

Additionally is there any way to move, or edit where a macro shows in the list of macro pages?

D-One

I think its all covered here:

https://www.native-instruments.com/ni-tech-manuals/maschine-software-manual/en/audio-routing%2C-remote-control%2C-and-macro-controls.html#creating-custom-sets-of-parameters-with-the-macro-controls

S Righteous

I figured it out - my Maschine manual doesn't even indicate how to set a macro!

But if you load up the software in stand alone, you can edit, label and re-arrange the macros in any order you like. Otherwise you have zero control over this stuff from what I can see if you use the software as a plug-in.

D-One

I think its all covered here:

https://www.native-instruments.com/ni-tech-manuals/maschine-software-manual/en/audio-routing%2C-remote-control%2C-and-macro-controls.html#creating-custom-sets-of-parameters-with-the-macro-controls

S Righteous

I have a downloaded manual - I think I need an update!