Komplete 14 CE Integration with Traktor?

DiosGnosis

Hello All,

I've been a closet producer for over a decade now. Very familiar with the Maschine hardware/software duo and have recently (at the interest and curiosity of my children) begun to dabble with the Traktor 4 Pro software.

I currently have a Maschine Mikro MK3, Maschine Studio, Maschine+, Komplete M32, and a Traktor Kontrol F1. I'm also a Komplete 14 CE owner.

I mention the hardware in hopes that some of you out there can assist in the following:

• Komplete 14 CE integration w/ Traktor software (access to samples, one shoots, loops etc)
• Clever hardware setups (including midi mappings if possible) utilizing the current hardware I have on hand

If the info for integrating my Komplete 14 CE files into the Traktor software can be found online, a link would be welcomed!

Thanks in advance for any assistance.

MB Pro - M3 Pro - Sonoma (current)

Uwe303

Hello,

here is the best source for traktor midi mappings, if you select your maschine model you can see all the mappings made for it to work with traktor.

https://maps.djtechtools.com/mappings?search%5Bsoftware_id%5D=29

this might help too:

https://www.youtube.com/watch?v=1vv6wlHUed8

integrating other stuff is a bit more complicated, you can of course use the sampler module and browse all samples from komplete 14ce and load them from the install folders. You can also run both software at the same time and make crazy routings. But in your case i would use the maschine+ and the F1 for traktor, you don´t need a mixer for that, you can also connect the m+ to the input of your audio interface and activate hardware monitoring so the maschine signal get routed to the main outputs as the traktor main outputs. Or you route maschine through traktor……many many options. But as i said above m+ and F1 is the way to go, you can later change the setup if you miss something, like a maschine as traktor fx controller, or as a controller for a sample deck…..

Uwe303

No problem, you are welcome, if you have any further questions just ask

Uwe303

Hello,

here is the best source for traktor midi mappings, if you select your maschine model you can see all the mappings made for it to work with traktor.

https://maps.djtechtools.com/mappings?search%5Bsoftware_id%5D=29

this might help too:

https://www.youtube.com/watch?v=1vv6wlHUed8

integrating other stuff is a bit more complicated, you can of course use the sampler module and browse all samples from komplete 14ce and load them from the install folders. You can also run both software at the same time and make crazy routings. But in your case i would use the maschine+ and the F1 for traktor, you don´t need a mixer for that, you can also connect the m+ to the input of your audio interface and activate hardware monitoring so the maschine signal get routed to the main outputs as the traktor main outputs. Or you route maschine through traktor……many many options. But as i said above m+ and F1 is the way to go, you can later change the setup if you miss something, like a maschine as traktor fx controller, or as a controller for a sample deck…..

DiosGnosis

@Uwe303

Thanks for this! I had a suspicion mappings existed somewhere. And your advice for which hardware to use from what is on hand will go far indeed!

Thanks for your assist.

Uwe303

No problem, you are welcome, if you have any further questions just ask