SIAC Event-Loop Error

prof_lofi
prof_lofi Member Posts: 9 Member

Hi Everyone,

I'm trying to use the old (brilliant) SIAC ensemble but getting the following error:

"Event-Loop occured in Module"

I've disabled event-loops globally in preferences but it doesn't fix it.

I'm on Mac M1Pro, latest version of Reaktor.

Any help appreciated.

Best,

Bill

Comments

  • ANDREW221231
    ANDREW221231 Member Posts: 347 Pro

    one thing that can often be done to avert event loops is to "re-clock" the feedback event signal, usually with an event from whatever feedback signal is being combined with

    in fact i usually regard not doing this in the fist place as bad circuit design in reaktor. if you don't know what that means you could upload the ensemble, or i could post an example

  • drb
    drb Member Posts: 5 Member

    Assuming this is zootook's Synth-in-a-Case, this is a very old ensemble that does use event loop(s). So event loops need to be enable globally (settings/preferences) and for the ensemble (function).

    Prior to the event iterator module in R4. , event loops were the only way to do some things, but dangerous.

    HTH

    drb

  • ANDREW221231
    ANDREW221231 Member Posts: 347 Pro

    ohhhh snap would that be the routing matrix?

    think i looked into that thing one time and found the abyss. too sketchy to mess with

    think there was a different version that used a more conventionally built routing matrix, if that was indeed the problem structure

Back To Top