How to run Set up Wizard on a second-hand Traktor S2 MK3 for a complete beginner ?

NVM
NVM Member Posts: 2 Newcomer
edited October 22 in Traktor Software & Hardware

Hi there,

I'm a total beginner in mixing. I bought a second-hand Traktor S2 MK3 a few weeks ago.

I did install Traktor Kontrol S2 but I would like to run the Set up Wizard to start as if I was the primary owner of the controller.

I've read the instructions manual carefully but somehow did not find any clue on how to do this.

Could you please help me out with that ? Or tell if there's not point trying to run the Set up Wizard, which had been probably run by the primary owner.

Thanks for your help.

Best Answer

  • Uwe303
    Uwe303 Moderator Posts: 4,017 mod
    edited July 23 Answer ✓

    Hello,

    within TP2/TP3 you open the preferences window in traktor, then on the bottom of that window you have a button to start the wizard. If you already have TP4 i don´t know where the wizard is gone.

Answers

  • Uwe303
    Uwe303 Moderator Posts: 4,017 mod
    edited July 23 Answer ✓

    Hello,

    within TP2/TP3 you open the preferences window in traktor, then on the bottom of that window you have a button to start the wizard. If you already have TP4 i don´t know where the wizard is gone.

  • NVM
    NVM Member Posts: 2 Newcomer

    Thanks for the tip :)

This discussion has been closed.
Back To Top

Categories