Setup:
Z2 Mixer
Control Vinyl MK2 (New)
Needles
PC: i9 13900KF
192 Samples
2 ms USB Buffer
I have encountered an issue after playing for extensive periods of time. It continues after resetting software, restarting computer.
About an hour into sets, one channel chooses not to calibrate. I have changed buffer sizes, re-routed channels, tested input levels, tested cables, changed tempo settings, Auto/master sync settings, reset tempo. Nothing.
Attempted vinyl mode and signal works fine, needles are fine, swapped DVS records, and signal is strong. Issue happens in Deck B , I swapped deck B by routing to deck D, it chooses to work only if I play from deck D. Calibrates, fine on deck D, A and C using same needles, DVS record, turntable, physical connection is on Channel B phono. Deck B although signal meter shows is just as strong, calibration stays grayed out, says to check needles and record. Calibration fails.
I have a suspicion it might be a glitch in the software for a deck that is playing for a long time? or some deck setting I have not figured out.
Any ideas?