My PC was setup so my Native Instrument content was on G:. Native Access File Management was configured as so:
My C: drive died, so after installing a new drive and then going through the process of installing a new OS and Native Access, I was under the assumption I could point Native Access to the content on G: and it would start using it.
Sadly, this isn't the case. When configuring Native Access File Management to the above picture, refreshing, closing/opening Native Access and restarting the PC, all content has the option of "Install".
If I click the ellipses for a piece of content, I have the option of Locate:
This allows me to select a location where the piece on content is. If I select Content, then I get an error:
If I select the specific folder:
I get a success message:
When I go to another piece of content, it ignores my initial setting of G:\Native Instruments\Content and instead uses the setting of the last piece of content I manually installed:
Manually selecting the appropriate folder works, but the problem here is that I have over 200 pieces of content. Am I expected to do this with every piece of content??
I read about a Relocate All option, but that does not appear for me.
How do I have Native Access read what I already have on a hard drive, without having to manually specify the folder for each individual piece of content?
