Iteration -multidisplay
I've got some issues with iteration and multi display
The multidsplay is set to 8 elements and set to block for elements ( -1 )
The iteration needs to adress the index first ( y1-y2 are constant) and then for each index the x1-X2 ..but so far no luck , only one element shows up
If the iteration spits out a stream of numbers ( 8 in this case ) and these go into an order module .
The first output directly goes to idx , and teh second is the stream of 1,2,,..,8 multiplied by the reciprocal of the Nr.of elements ( 1/8) which is 0.125 , this sets the X1 value , a small value is added to set X2.
My question is the order of events from iteration into order module to it's outlet ,which s crucial .
Does the order module processes the whole stream at once , or does it receive the next number only when the previous one has left all it's outputs ?
Example .
-Order It recieves nr 1 fom Iter , goes out first output of order into idx of multi ( idX 1 is now selected )
Now goes out of second ouptut of order into x1 , etc…( this should be the correct and it was I did )
Each index and it's x1-X2 parameters can only be correctly received by the multidisplay when the order module aso handles them sepearately .
Hopes it makes sens
This is one of those moment where one ask how it's possible that reaktor does not and never had a decent debugging console .
Categories
- All Categories
- 19 Welcome
- 1.5K Hangout
- 61 NI News
- 774 Tech Talks
- 4K Native Access
- 16.4K Komplete
- 2K Komplete General
- 4.3K Komplete Kontrol
- 5.7K Kontakt
- 1.6K Reaktor
- 376 Battery 4
- 835 Guitar Rig & FX
- 425 Massive X & Synths
- 1.3K Other Software & Hardware
- 5.7K Maschine
- 7.2K Traktor
- 7.2K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators