Traktor/Mac: How to pre-listen via Audio6 Soundcard?

Hey there, I need help with the following set-up:
• Traktor (Mac)
• Audio6 (Soundcard)
• Amp/Speaker
• Headphone
but no external Mixer.
I have plugged the Amp to Audio6 Frontpanel > Main Output (Chinch), works well so far.
But how to connect the Headphones, so that I can pre-listening to the other deck?
Thank you in advance
Sascha
Answers
-
So, in Traktor, I have configured
Output Monitor: Ch A left & right
Output Master: Main Left & Right
Then, on the Audio6-Soundcard, I have plugged the Amp to
front panel -> Main Out
and the headphones (via 3,5 to chich adaptor) plugged to the back panel -> CH A left & right, but there is no signal coming out, even if I swap master & monitor. No music is being played via Ch A. Same with Ch B.
Can you please help me with this?
Thank you in advance and kind regards
0 -
Welcome to the forum.
You need to connect the headphones to the front Main 1/4" jack input. That's where Traktor will route the monitor output. Connect your Cinch/RCA cable to Outputs 3 & 4 to go to your amp/speaker.
The routing is:
Let me know how you get on.
Karlos.
0
Categories
- 4.8K All Categories
- 17 Welcome
- 228 Hangout
- 35 NI News
- 102 Tech Talks
- 421 Native Access
- 2.2K Komplete
- 243 Komplete General
- 477 Komplete Kontrol
- 853 Kontakt
- 241 Reaktor
- 73 Battery 4
- 141 Guitar Rig & FX
- 106 Massive X & Synths
- 84 Other Software & Hardware
- 1.2K Maschine
- 11 Sampling Room
- 1K Traktor
- 858 Traktor Software & Hardware