Audio renderer error when using Machine Mikro mk3 and Youtube

Red Rat
Red Rat Member Posts: 4 Newcomer
edited October 2024 in Maschine

I know that i am not the only person to ask this question, i see some other users from a couple of years ago with the same issue, so i am hoping that this is something that was addressed and fix by now.

I just bought a Mikro mk3 and when i open the Machine 2 software, the play back is fine, i can hear the sounds when i use the pads and everything works ok.

I did not change any of the default settings in the setup, so i dont think that this is the issue.

However when i open Youtube (or any other video playback) i get an error message "audio renderer error. Please restart your computer" and the video can not play.

When i close the Machine 2 software and try the video again, the video will play, but just not with the Machine 2 software open.

I have looked at the usual advise about "updating audio driver" "uninstalling audio drivers" "roll back drivers" "update bios" ect ect but none of this works and does not fix anything.

Also i dont have any issues with the other external hardware that i use doing the same thing in any other DAW or recoding software, its just this Mikro mk3 that has this issue and its only started doing this that last couple of day since i started using this device.

So i am hoping that there is a fix for this, or some kind of work around.

Thanks in advance.

This discussion has been closed.
Back To Top