Hello everyone,
I have recently started using the NI Komplete Audio 6 MK2 interface together with Traktor 3 Pro (version 3.8.0). I loaded the drivers via the Native Instruments page and selected them accordingly in the Audio Setup settings. From the sound card I then go to the club mixer via the outputs Out 1/2 and Out 3/4 with the appropriate cables (2x6.3 mm jack to 2x RCA) into 2 channels. Today I had a sound problem, after about 2 hours the sound of the sound card suddenly sounded strangely distorted in the middle of the song and the song seemed slightly slowed down, even though I hadn't changed anything in the driver settings. I then shut down the program and restarted it. After that it worked again, but I suspect I still set the wrong driver in the audio setup setting. Is there anything important to note here? Which driver do I use:
Komplete Audio 6 MK 2 (WASAPI (Shared Mode)) or Komplete Audio ASIO Driver (ASIO)?
Which buffer size (settings) should be set for the ASIO driver? 512 samples? Or more/less?
Do I have to pay attention to anything when setting up External Sync? Enable MIDI Clock Settings? Yes or no?
I suspect that I used the wrong driver (WASAPI (Shared Mode)) because I always had the ASIO driver set on my old Audio 4 DJ sound card. I just noticed it too. However, the (WASAPI (Shared Mode)) worked for about 2 hours, so I'm currently wondering what could have caused that? I would be very grateful for any help and tips! Best regards
