Explanation of DFD vs Sampler modes
dougUnsung
Member Posts: 1 Newcomer
Hi, I'm new at KSP and just getting the basics down. Can someone explain to me the difference between DFD and Sampler modes (and/or any of the other modes)? I'm only using the old Kontakt3 PDF lol. Thanks.
0
Comments
-
this is a read the manual thing, but essentially Sampler mode is playing back from RAM, DFD is playing back from disk. original hardware samplers were only playing back from RAM, and ideally it's still the highest performance method. DFD relies less on your precious RAM but is slower (not by much these days).
0
This discussion has been closed.
Back To Top
Categories
- All Categories
- 19 Welcome
- 1.5K Hangout
- 62 NI News
- 785 Tech Talks
- 4.1K Native Access
- 16.5K Komplete
- 2K Komplete General
- 4.3K Komplete Kontrol
- 5.7K Kontakt
- 1.6K Reaktor
- 378 Battery 4
- 845 Guitar Rig & FX
- 429 Massive X & Synths
- 1.3K Other Software & Hardware
- 5.8K Maschine
- 7.3K Traktor
- 7.3K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators