Mac / Maschine only works if I open Controller Editor

NicolasG
NicolasG Member Posts: 10 Member
edited October 2024 in Maschine

Hey there,

I encountered if I connect my Maschine Mikro Mk3 to my Macbook M1, it lights up and then shuts down. It only goes into working mode and midi mode if I open the NI Controller Editor once (I can close it after that). Then there is no problem, but the issue comes back if I reboot the Mac.

Any idea what's going on? Do I need to have something running in the background or missing drivers?

Best Answer

Answers

  • Jeremy_NI
    Jeremy_NI Administrator, Customer Care Posts: 14,506 admin
    edited September 2023

    @NicolasG Have you installed the Maschine software? Does the Maschine software have full disk access ? How to Enable Full Disk Access on macOS

    Also, to be sure. If the Mikro MK3 is connected without the Maschine software on or Controller Editor you need to push SHIFT + the Maschine logo button, top left of the Mikro Mk3.

  • Elvislives77
    Elvislives77 Member Posts: 13 Member

    I have this same problem. All NI software listed has disk access although Maschine is greyed out which suggests to me it doesn’t need disk access. I have pressed the shift+maschine logo but this has no effect.

    None of the buttons light up until I go into the NI Controller Editor.

  • Elvislives77
    Elvislives77 Member Posts: 13 Member

    Have now tried setting Control Editor to open on start up of computer. It doesn’t work. Control Editor has to be physically opened.

  • NicolasG
    NicolasG Member Posts: 10 Member

    So sorry to hear you have the same problem. I‘m still having the same issue as well.

  • Jeremy_NI
    Jeremy_NI Administrator, Customer Care Posts: 14,506 admin
    edited December 2023

    @NicolasG Oh, this is still happening? Sorry to hear that.

    @Elvislives77 Do you also have the issue with a Mikro Mk3? Do you also have a M1 computer?

  • Elvislives77
    Elvislives77 Member Posts: 13 Member

    yes Mikro mark 3 but my computer is MacBook Pro 2020 on intel chip.

  • Jeremy_NI
    Jeremy_NI Administrator, Customer Care Posts: 14,506 admin
    Answer ✓

    @Elvislives77 You said that the Maschine software does not have full disk access, if I read correctly, it is important to give full disk access to the Maschine software: How to Enable Full Disk Access on macOS

    Have you tried these steps? My Maschine Controller Does Not Start

  • NicolasG
    NicolasG Member Posts: 10 Member

    @Jeremy_NI This worked for me now. Thank you! I wish NI's software would ask for full disk access during setup so we can avoid manually going into settings and do stuff. Maybe something for a future update.

  • Elvislives77
    Elvislives77 Member Posts: 13 Member

    This has worked for me as well. Thank you so much.

This discussion has been closed.
Back To Top

Categories