Strange behaviour of Komplete S61 MK2 mod wheel

Witold Suryn
Witold Suryn Member Posts: 2 Member
edited October 22 in Komplete General

Hi,

In my S61 I have recently noticed a strange behaviour of the mod wheel. The wheel turns 180 degrees but it begins to send CC1 values from about 45 degrees (CC1=0) and ends about 135 degrees (CC1=127), which makes distribution of 127 points over 90 degrees instead of 180. Naturally the precision of manipulation diminishes in half, which makes the wheel practically useless. I have created a ticket with NI, but, obviously, I was entirely ignored, so perhaps on this forum there are people who experienced a similar problem and even found a solution. If yes, could you, please, share?

Witold

Best Answer

  • Jeremy_NI
    Jeremy_NI Customer Care Posts: 12,971 mod
    Answer ✓

    @Witold Suryn That really looks like a hardware issue. We're really sorry that no one got back to you yet. I've escalated your issue and someone should get back to you.

Answers

  • Jeremy_NI
    Jeremy_NI Customer Care Posts: 12,971 mod
    Answer ✓

    @Witold Suryn That really looks like a hardware issue. We're really sorry that no one got back to you yet. I've escalated your issue and someone should get back to you.

  • Witold Suryn
    Witold Suryn Member Posts: 2 Member

    Hi Jeremy,

    It would be most appreciated.

    Witold

  • Jeremy_NI
    Jeremy_NI Customer Care Posts: 12,971 mod
    edited March 2023

    My colleagues got back to you this morning. Sorry for the wait!

This discussion has been closed.
Back To Top

Categories