How To Map Midi Switches Properly In Guitar Rig 5

I have a midi pedal that is sending midi data to Guitar Rig 5. But the signal is a 0 and 1 value. not the typical 0 and 127. Guitar Rig reads the 0 and 1 values as an off position. So I'm stuck, never being able to turn anything on.
I've done my research on the pedal and it isn't editable. There is no editor for it. The pedal isn't necessarily built for this use case, but I'm hoping I can get it to work.
Is there a setting in Guitar Rig to read the midi values differently?
Thanks
Comments
-
What pedal are you using?
1 -
Behringer FCB1010 with a Uno4Kemper chip upgrade.
Again. I realize this pedal isn't built for this use case. But I've seen others using it for this purpose. I just can't seem to find what I'm missing on the GR5 side.
0 -
Behringer FCB1010 with a Uno4Kemper chip upgrade.
Again. I realize this pedal isn't built for this use case. But I've seen others using it for this purpose. I just can't seem to find what I'm missing on the GR5 side.
0
Categories
- 10.8K All Categories
- 22 Welcome
- 451 Hangout
- 59 NI News
- 210 Tech Talks
- 1.1K Native Access
- 5K Komplete
- 626 Komplete General
- 1.1K Komplete Kontrol
- 1.9K Kontakt
- 492 Reaktor
- 160 Battery 4
- 272 Guitar Rig & FX
- 203 Massive X & Synths
- 211 Other Software & Hardware
- 2.3K Maschine
- 14 Sampling Room
- 2.7K Traktor
- 2.4K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators