How come I can't find Automation tab in Kontakt 7? (7.5.0)

Options
Ugurcan
Ugurcan Member Posts: 6 Member
edited October 2024 in Kontakt

I clicked every button but can't find how to to open Side Pane, Master or Outputs views without going into wrench-mode. And in the wrench mode, it's impossible to drag-drop a knob to a host automation since the UIs get garbled.

How come this is a good idea again?

Edit: After a bit mingling, I understood "Minimize" button actually toggles views, but it's not so obvious when only the "Multi Rack" view toggles by default. Uh.

Tagged:

Best Answer

  • Jeremy_NI
    Jeremy_NI Administrator, Customer Care Posts: 14,941 admin
    Answer ✓

    As you said @Ugurcan, I'm just copying/pasting here as it might help users out there: "Minimize" button actually toggles views, but it's not so obvious when only the "Multi Rack" view toggles by default. Here's the minimize/maximize button to have the other sections:

    Screenshot 2023-07-19 at 16.20.17.png


Answers

  • Uwe303
    Uwe303 Moderator Posts: 4,831 mod

    Hello,

    so you figured out on your own?

  • Jeremy_NI
    Jeremy_NI Administrator, Customer Care Posts: 14,941 admin
    Answer ✓

    As you said @Ugurcan, I'm just copying/pasting here as it might help users out there: "Minimize" button actually toggles views, but it's not so obvious when only the "Multi Rack" view toggles by default. Here's the minimize/maximize button to have the other sections:

    Screenshot 2023-07-19 at 16.20.17.png


This discussion has been closed.
Back To Top

Categories